Kinerja Motor Induksi 1-fasa Disain 4 Kumparan dengan Kapasitansi Kapasitor Jalan Terkendali
DOI:
https://doi.org/10.26418/elkha.v12i1.37857Keywords:
single phase induction motor, current control system, Arduino Uno, 4 windings construction.Abstract
Single phase induction motor usually has two windings. Because of that, the motor usually operated at lower efficiency than the poly-phase induction motor. A new design had been developed by using poly-phase winding to improve motor efficiency, but characteristic of the current winding at low load condition is not good. So that, this study was aimed to design a 4 phase windings construction of a single phase induction motor that using capacitance control of the run capacitor on auxiliary winding. This design was focused for capacitor-start capacitor-run induction motor that had 4 windings, one winding act as the main winding and the other three windings act as the auxiliary windings. The main and the auxiliary windings current rating of the proposed motor were 2.74A and 3.15A, respectively. The auxiliary winding current of the proposed motor was controlled by the "˜Arduino Uno"™ control system. To get the best control system of the proposed motor, the performances of the proposed motor were compared to the performances of a conventional single-phase induction motor that had the same current rating, stator and rotor construction. The single-phase comparator motor used in this study was a conventional single-phase induction motor of 220V, 50 Hz, 1 HP, 8.3A, 4 poles, 1400 RPM cage rotor. The result showed that the proposed motor with capacitance control in auxiliary winding had better performances than the conventional induction motor.References
P. C. Sen, Principles of Electrical Machines and Power Electronics, 2nd ed. New York: John Wiley & Sons, 1997.
S. J. Chapman, Elecrical Machinery Fundamentals, 4th ed. New York: McGraw-Hill, 2005.
A. Nied and J. De Oliveira, “Improving Washing Machine Performance Using Single-Phase Induction Motor Field-Oriented Control,†pp. 2917–2922, 2013.
H. M. B. Metwally, “New method for speed control of single phase induction motor with improved motor performance,†Energy Convers. Manag., vol. 42, no. 8, pp. 941–950, 2001.
S. Sobhani, H. Yaghobi, and M. Samakoosh, “Optimize efficiency and torque in the single-phase induction motor by adjusting the design parameters,†12th Int. Conf. Environ. Electr. Eng. EEEIC 2013, pp. 237–241, 2013.
T. Liu, M. Lin, and H. Wu, “A single phase induction motor drive with improved performance,†vol. 47, pp. 29–38, 1998.
Z. Anthony and E. Erhaneli, “Desain Lilitan Motor Induksi 1-Fasa dengan 4 Kumparan yang Tidak Identik Sama ( Studi kasus: daya keluaran dan efisiensi motor),†EECCIS, vol. 12, no. 2, pp. 89–92, 2018.
Z. Anthony, E. Erhaneli, and Z. Zulkarnaini, “Windings Design for Single-phase Induction Motors Base on 4- phase Induction Motor ( Case study : identical windings design ),†in ICTIS 2018, 2018, vol. 01023, pp. 1–4.
Z. Anthony and E. Erhaneli, “A New Windings Design of 24 Slot Capacitor-Start Capacitor-Run Induction Motor,†vol. 8, no. 5, pp. 3463–3470, 2018.
Z. Anthony and E. Erhaneli, “Disain Baru Bentuk Lilitan Kumparan Motor Induksi 1-fasa Berbasis Bentuk Lilitan Motor Induksi 3-fasa,†in PIMIMD-4 2017, pp. 245–249, 2017.
Z. Anthony and E. Erhaneli, “A New Winding Design for Single Phase Induction Motor,†in ICo-ASNITech 2017, pp. 153–160, October, 2017.
J. C. White and H. Huang, “OPTIMAL PLACEMENT OF THE RUN CAPACITOR IN SINGLE-PHASE INDUCTION MOTOR DESIGNS,†IEEE Trans. Energy Convers., vol. 3, no. 3, pp. 647–652, 1988.
Downloads
Additional Files
Published
Issue
Section
License
Copyright (c) 2020 ELKHA : Jurnal Teknik Elektro
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
1. Proposed Policy for Journals That Offer Open Access
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
2. Proposed Policy for Journals That Offer Delayed Open Access
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication, with the work [SPECIFY PERIOD OF TIME] after publication simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
