ANALISIS PEMBANGKIT LISTRIK DENGAN GENERATOR STIRLING

Authors

  • Harry Iqbal Al-Fikri .

DOI:

https://doi.org/10.26418/j3eit.v2i1.5019

Abstract

- In this study, using the Stirling Generator TE specification (temperature hot) = 350 ° C = 623 K, TC (Cold Temperature) = 50 ° C = 313 K, fluid work = 286 J / (Kg.K), and the angle between the cylinder expansion cylinder compression (dx) = 90 °, the piston diameter (D) = 51 m = 0.051 m, length of step / Stroke (S) = 54 mm = 0.054 m, volume expansion (VE) and the compression volume (Vc) = 3.086 x 10 -4 m3, Stirling Speed ​​= 750 rpm (assumed), maximum pressure = 325,266.95 Pa, Power = 401.18 Watts at 750 rpm. Based on the analysis of output power depends on the difference in air temperature in the cylinder heat with the air temperature in the cold cylinder, the working fluid is used, and the angle between the cylinder and the cylinder compression expansion. The comparison of work output to the heat input so that the Stirling Generator efficiency scores are good enough to use a power plant.

Downloads

Published

2014-03-21

Issue

Vol. 2 No. 1: Januari 2014

Section

Articles

License

Authors who publish with this journal agree to the following terms:

  • Copyright of the published articles will be transferred to the journal as the publisher of the manuscripts. Therefore, the author confirms that the copyright has been managed by the publisher.
  • Publisher of J3EIT is  Universitas Tanjungpura.
  • The copyright follows Creative Commons Attribution"“ShareAlike License (CC BY SA): This license allows to Share  "” copy and redistribute the material in any medium or format, Adapt  "” remix, transform, and build upon the material, for any purpose, even commercially.